Eizo eClient SC1 Manual de usuario descargar pdf (Pagina 27)

English

3. Click the [Check if the network environment is suitable for

downloading the firmware.] check box to check the network

environment.

4. Click [OK].

NOTE

• The status of the selected Client(s) becomes “Processing” while checking the

network environment, and returns to “Up” after Client(s) receives the firmware.

An error message will appear if the network communication has trouble.

5. Right-click on the target Client and select [Client]-[Store Firmware]

again.

6. If restarting the Client(s) after storing, click the check box of [Restart

the Client after storing the firmware].

NOTE

• If the Client(s) doesn’t restart after storing the firmware, the firmware has not

been updated.

• The Windows XPe-based Client Terminal restarts 3 times automatically. Then,

the stored firmware file will be enabled.

7. Click [OK]. The following warning message will appear.

Click [Yes] to store the firmware in the selected Client Terminal(s).

NOTE

• Follow the warning message if the firmware has not been stored. The wrong

operation will prevent the Client(s) from restarting.

• After the firmware has been updated, restarting the Client(s) causes the IP address

to return to the default. When a DHCP server is not used, any command from

Network Administrator cannot be controlled until an IP address is specified to each

Client directly.

3. BASIC OPERATION

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 55 56

Sin comentarios

Eizo eClient SC1 Manual de usuario Pagina 27